Setting up your Dartboard Tripod can't really get much easier! Follow these step-by-step instructions or watch the short handy video below.
1. Your tripod will come collapsed in it's box. Remove from the box.
2. Hold the tripod upright (vertical) and pull down on the one of the legs to open them out. Splay the legs out as far as they will go until the center pole is rested down.
3. Firmly tighten the knob at the base of the tripod/top of the legs.
4. Loosen the knob half way up the tripod pole and lift the pole upwards from above the knob. Using your tape measure, measure a height of 1.73m from the ground to the screw hole at the top of the baseplate (this will be bullseye). Once you have your 1.73m measurement correct, tighten the knob on the pole to fix it into place.
5. Next, fitting your dartboard. Rest your board on the curved baseplate near the top of the tripod and using the main screw from the center of your board, screw the board to the tripod from behind the tripod plate. For extra stability, if you wish, you can fit two smaller screws in the lower part of the tripod baseplate, into your board.
6. If you want to, you can now apply a 1-piece surround to the outside of your board.
You're good to go!